December 23, 2024, 11:19:41 AM
Forum Rules: Read This Before Posting


« previous next »
Pages: [1]   Go Down

Topic: Water extended polyester  (Read 7523 times)

0 Members and 1 Guest are viewing this topic.

Offline beakerwasher

  • New Member
  • **
  • Posts: 3
  • Mole Snacks: +0/-0
Water extended polyester
« on: February 05, 2010, 12:40:52 PM »
Hi everyone,

Can anyone tell me anything about casting water extended polyester, its uses and so on?

Thanks
Logged

Offline Schrödinger

  • Chemist
  • Sr. Member
  • *
  • Posts: 1162
  • Mole Snacks: +138/-98
  • Gender: Male
Re: Water extended polyester
« Reply #1 on: February 05, 2010, 12:48:08 PM »
Logged
"Destiny is not a matter of chance; but a matter of choice. It is not a thing to be waited for; it is a thing to be achieved."
- William Jennings Bryan

Offline beakerwasher

  • New Member
  • **
  • Posts: 3
  • Mole Snacks: +0/-0
Re: Water extended polyester
« Reply #2 on: February 05, 2010, 01:56:47 PM »
Thanks for the prompt reply!  Yes, I've looked at this site already.  I was after more technical information, possibly looking at blowing the system.
Logged

Offline typhoon2028

  • Full Member
  • ****
  • Posts: 251
  • Mole Snacks: +18/-12
Re: Water extended polyester
« Reply #3 on: February 11, 2010, 01:05:05 PM »
Are you trying to foam the system?
Logged

Offline beakerwasher

  • New Member
  • **
  • Posts: 3
  • Mole Snacks: +0/-0
Re: Water extended polyester
« Reply #4 on: February 11, 2010, 01:43:12 PM »
yes
Logged

Offline typhoon2028

  • Full Member
  • ****
  • Posts: 251
  • Mole Snacks: +18/-12
Re: Water extended polyester
« Reply #5 on: February 12, 2010, 10:39:45 AM »
The WEP should form an emulsion. 

You could mix and inject air or CO2.

What expansion are you looking for?

There are chemical blowing agents that will decompose with heat.
Logged
Pages: [1]   Go Up
« previous next »
Sponsored Links