December 26, 2024, 06:45:14 PM
Forum Rules: Read This Before Posting


« previous next »
Pages: [1]   Go Down

Topic: Using Manual Injection with an Autosampler  (Read 2962 times)

0 Members and 1 Guest are viewing this topic.

Offline Friholio

  • Very New Member
  • *
  • Posts: 1
  • Mole Snacks: +0/-0
Using Manual Injection with an Autosampler
« on: January 19, 2018, 04:59:10 PM »
So the transport assembly on my lab's Agilent 1100 G1313A autosampler (older than dirt, I know) has s#*$ the bed. In the meantime we would like to still run samples through the HPLC via manual injections. I cannot seem to find any information on how to set that up in our HP ChemStation (version A.08.03) software. Anyone know how to accomplish this?
Logged

Offline marquis

  • Full Member
  • ****
  • Posts: 434
  • Mole Snacks: +38/-3
Re: Using Manual Injection with an Autosampler
« Reply #1 on: February 01, 2018, 01:58:14 PM »
Now that you mention it, I've never seen a manual injector on an 1100. 

The model before the 1100 had the manual injector as part of the column heater assembly.  As a start, try looking over the column heater to see if you can find a manual injector somewhere there.

Good luck.
Logged

Offline Babcock_Hall

  • Chemist
  • Sr. Member
  • *
  • Posts: 5715
  • Mole Snacks: +331/-24
Re: Using Manual Injection with an Autosampler
« Reply #2 on: February 01, 2018, 05:04:08 PM »
We have often used manual injections on our 1100.  Is your question about software or hardware?
Logged
Pages: [1]   Go Up
« previous next »
Sponsored Links