November 24, 2024, 06:38:57 PM
Forum Rules: Read This Before Posting


« previous next »
Pages: [1]   Go Down

Topic: GC-MS INlet Pressure Problem  (Read 7277 times)

0 Members and 2 Guests are viewing this topic.

Offline agartnet

  • Very New Member
  • *
  • Posts: 2
  • Mole Snacks: +0/-0
GC-MS INlet Pressure Problem
« on: August 15, 2007, 10:27:08 AM »
Hi all,

I have a problem with a 5890 series II GC where the electronic pressure program (EPP) is not working. It had been working fine, but recently it says "EPP not installed", and I was wondering if anyone has any ideas what the problem is and any possible ways to fix it. This also disables the flow reading on the instrument.
Thanks
Logged

Offline Mr Peanut

  • Regular Member
  • ***
  • Posts: 96
  • Mole Snacks: +5/-3
Re: GC-MS INlet Pressure Problem
« Reply #1 on: August 15, 2007, 05:04:55 PM »
Call the 800 number. I have always had good results with this approach. (But, be nice or they may charge you.)
Logged

Offline agartnet

  • Very New Member
  • *
  • Posts: 2
  • Mole Snacks: +0/-0
Re: GC-MS INlet Pressure Problem
« Reply #2 on: August 16, 2007, 02:27:58 PM »
I did and they were less than helpful...they basically told me that my instrument was old, none of the parts were made or serviced anymore and that I'd have to look second hand to repair it, even though the engineer couldn't even tell me the exact problem
Logged

Offline Mr Peanut

  • Regular Member
  • ***
  • Posts: 96
  • Mole Snacks: +5/-3
Re: GC-MS INlet Pressure Problem
« Reply #3 on: August 16, 2007, 07:12:14 PM »
Sorry

Yea, I’ve heard that myself. Once in a while you get someone helpful.

My approach has always been to take the entire thing apart and then reassemble it. Most of the time this either reveals the problem or it simply, mysteriously fixes it.
Logged
Pages: [1]   Go Up
« previous next »
Sponsored Links