November 27, 2024, 02:50:11 AM
Forum Rules: Read This Before Posting


Topic: Forcing electrolytes out of solution with acetone  (Read 2106 times)

0 Members and 1 Guest are viewing this topic.

Offline CrimpJiggler

  • Full Member
  • ****
  • Posts: 113
  • Mole Snacks: +5/-3
Forcing electrolytes out of solution with acetone
« on: October 20, 2011, 10:01:45 AM »
I read that, similar to how non electrolyte solutes can be "salted out" of solution, electrolyte solutes can be forced out of solution with organic compounds. I know NaCl is practically insoluble in acetone so would I be right in assuming I could cause NaCl to precipitate out of a saturated sodium chloride solution (NaCl/H2O solution) by adding enough acetone?

Offline Honclbrif

  • Chemist
  • Full Member
  • *
  • Posts: 659
  • Mole Snacks: +58/-10
  • Gender: Male
Re: Forcing electrolytes out of solution with acetone
« Reply #1 on: October 20, 2011, 11:37:24 AM »
It would probably work, but it might take a LOT of acetone, depending on how much salt and how much water you have.
Individual results may vary

Offline fledarmus

  • Chemist
  • Sr. Member
  • *
  • Posts: 1675
  • Mole Snacks: +203/-28
Re: Forcing electrolytes out of solution with acetone
« Reply #2 on: October 20, 2011, 11:45:31 AM »
Sometimes it can. If your aqueous solution is saturated with NaCl, however, you can actually force the acetone out of the water to form a second layer.

Methanol can be used to precipitate sodium chloride from an aqueous solution, and I've never seen it form a second layer regardless of how concentrated the solution is.

Sponsored Links